- Inverter: 2.5 kW continuous, 6 kW surge capacity
- Battery Storage: 20 kWh (800 Ah @ 24 V)
- Solar Array: 0.7 kW at 48 VDC
- Solar Power (summer peak): 4 kWh/day
plus up to 15% more power from the MX60 maximum power point tracking (MPPT) controller!
Designed for those that will be living off grid full time, this system provides you with the charging and storage that a modest house off grid will require.
This system includes a Sealed Inverter from Outback. Why sealed? A sealed inverter is protected from bugs, dust and excessive moisture, common killers of power electronics. A sealed inverter gives your inverter a level of protection that was not possible before, which is added piece of mind for you. The Outback inverters produce pure sine wave power, as good or better than the power that you would receive from the utility company. On top of good quality of power you can expect reliability from your power system that is better then the utility grid!
With power output warrantied for 25 years these modules are an investment you can depend on to produce for a long, long time. We have combined the solar array with the Outback MX60 maximum power point tracking (MPPT) advanced solar charge controller. This will allow you to have your solar array at a higher voltage than your batteries (up to 72V nominal) for cost savings on your transmission cable. This controller will give you an extra 15-25% more power from your solar array compared to the more common PWM controllers.
The batteries included in this system are Global-Yuasa 2 Volt cells. These batteries are tubular cells; this innovative design extends the life of batteries by reducing sulphation (the build up of sulphur crystals on the battery plates). Consequently, these batteries often last for 15-20 years. Batteries are the core of a renewable energy system and the Global Yuasa batteries will give your system the support the rest of the equipment needs to perform its best.
The inverter and most of the electrical components are built onto a steel back plate. This makes installation a snap and drastically reduces the amount of wiring needed to bring power to your home.
This system is designed to provide you with all the pieces that you will need. However, each site is specific and will require some modifications, please call us to customize this package for you.
These systems are not designed to handle any electrical heating loads because these loads demand so much power that they are not feasible for renewable energy systems. |
(800) 265-8898